EASA to issue own AD for Piper wing spars

EASA has decided NOT to adopt the final wing spar Airworthiness Directive affecting wing spars on some Piper PA-28 models. Instead, it will propose its own AD.  The UK CAA has yet to state its own position.

AD 2020-26-16 was announced by the US authority, the FAA, on 15 January 2021 and applies to certain PA-28 and PA-32 aeroplanes.

That AD requires calculating the factored service hours for each main wing spar to determine when inspection is required, a one-time inspection of the inner surface of the two lower outboard bolt holes on each lower main wing spar to detect cracks, and, depending on findings, replacing the cracked main wing spar.

“Although EASA agrees with the need for inspection, EASA cannot apply a method of ’factoring’ hours to determine when an inspection is required, as it could not be applied to flight hours as recorded for aircraft under EU regulation,” said EASA’s announcement.

“For the reason described above, EASA has decided not to adopt FAA AD 2020-26-16.

“However, EASA plans to issue a Proposed AD to address the safety risk addressed by FAA AD 2020-26-16 for aeroplanes operating under EU regulation.”

The FAA AD was prompted by a fatal accident involving wing separation on a Piper Model PA-28R-201. An investigation revealed a fatigue crack in a visually inaccessible area of the lower main wing spar cap.

‘Replaced anyway’ – Freedom Aviation

Freedom Aviation at Cotswold Airport (Kemble) operates six Piper PA-28 aircraft. It took the decision to go ahead and comply with the FAA AD anyway.

Head of Training Dave Jelly said, “This has been going on for two years on and off and when the FAA AD came out we just decided to do the lot anyway, just to be on the safe side.

“It’s a time-consuming process [to get to the bolt holes] but the probing takes five minutes per aircraft. The eddy current machine is very sophisticated and produces a detailed scan. Ours were all fine.

“You do have to be very meticulous when taking out the bolts – it’s easy to damage the bolt holes. The tester said ours were the best he’d seen. It cost us a week of flying, but at least it’s done now.”

FLYER has contacted the CAA’s AD Unit and we will publish their reply here when received.

This post was originally published by Flyer Magazine on . Please visit the original post to read the complete article.

Leave a Reply